Sanyo POA-PJNM01 All in One Printer User Manual


 
28
Chapter 3 Basic operation
Customizing the display columns
Changing the status column indication
1. Select
Column Selection from System menu. The setting window will appear.
2. On the window, check the column name you want to display on the status list view window .
Column Description
Target Name Name of the network equipment
Power Status Status of the network equipment (ON:Normal, OFF:Normal, OFF:P-Mng, Cooling,
CountDown, etc.)
Lamp Status Status of lamp (On, Off, Err, LampNonLight, etc. indicated with lamp1, lamp2, lamp3,
lamp4 sequentially)
Input Signal Name of input signal (Analog, Digital, S-Video, Video, Y/Cr/Cb, Y/Pr/Pb, etc.)
Input Status Status of input signal (On, Off, Interrupted)
Input Select Displays input mode (1,2,3 etc)
Network Status Status of network connection (Disconnect, Connect)
Temperature A Displays inside temperature A of the equipment (in Celsius or Fahrenheit)
Temperature B Displays inside temperature B of the equipment (in Celsius or Fahrenheit)
Temperature C Displays inside temperature C of the equipment (in Celsius or Fahrenheit)
Lamp Time Displays lamp use time (Indicated with lamp1, lamp2, lamp3, lamp4 sequentially)
IP Address Displays IP address of the equipment
Model Name Displays model name of the equipment
Projector Time Displays accumulated projector use time
PJ-Net Ver. Displays the version of the PJ Master or Network Board firmware
PJ Ver. Displays the version of the projector firmware
3. To change order of the display column on the status list, select column you intend to change order
and click To up or To down.
4. Click
OK to set the display column. The setting window will close.
* When specifying the column width by numeric value, enter number (0 to 9999) onto “Column width” text box.
* When changing the column width or column order on the status list view window, it is reflected to the
column selection window.
* Some of the column items may not effective depending on the connected target.