Filter
Top Products
SECTION 2: INSTALLATION
Page 2-8 SATO D508/D512 Operator Manual
6. Route the label material through the Paper
Sensor Assembly and over the Platen. Note
that the Sensor is part of the left Label Roll
Guide so that the Paper Sensor is always
positioned in the same location relative to
the left edge of the label.
7. Close the Top Cover.
8. Press the LINE button so that the printer is
in the OFF LINE mode and then press the
FEED button. The label should advance to
the next index (label gap) position.
Fanfold media
1. Place the fanfold media behind the printer
with the printing surface up.
2. Open the Top Cover by pressing on the cover
release latch located on the right-hand side
of the printer. This releases the cover and
allows it to swing upward on the rear
mounted hinge points.
3. Carefully pull up the Fanfold-label Loading
Slot from the back of the Top Cover.
4. With the Top Cover in the upright position,
press the Paper Guide Release while adjust-
ing the Paper Guides until they allow a media
to fit between them. A millimeter scale is
molded into the case to provide a guide when
making the adjustment. The Paper Guides
are center-justified and interact with each
other so that each moves an equal distance
apart from each other.
5. Route the label material through the Sensor
Assembly and over the Platen.
Paper Sensor Paper Guide
Platen
Pull up
the
loading
slot
Pull
open
the Top
Cover
Load
the
fanfold
paper
Fanfold-label Loading slot