Filter
Top Products
Section 3: Configuration and Operation
Page 3-8 SATO D508/D512 Operator Manual
3.5 OFFSETS
There are two offset settings stored in the printer; one for the Cut mode and one for the Tear-Off
mode.
These two offsets can be set independently and will remain in the printer until a new command is
received changing the setting or until power is turned off.
The default settings can be determined by printing a User Test Label.
The following should be used as starting points for establishing the three Offset values:
Mode Length of Offset (mm) Length of Offset (in) Print head resolution
CUTTER 17.9 0.70 143/215
TEAR-OFF 29.2 1.15 234/350