Filter
Top Products
Placing Originals
14
1
Placing Originals in the Auto Document Feeder (ADF)
Settings should be made in the following situations:
❖
❖❖
❖ When placing originals of more than 100 pages:
See p.15 “Batch mode”.
❖
❖❖
❖ When placing originals one by one:
See p.16 “SADF mode”.
❖
❖❖
❖ When copying originals of various sizes:
See p.16 “Mixed size mode”.
❖
❖❖
❖ When copying originals onto thin paper
See p.17 “Thin mode”.
❖
❖❖
❖ When placing custom size originals:
See p.18 “Placing custom size originals”.
Important
❒ If you turn on the machine with an original left on the exposure glass and
started copying while placing originals in the ADF, a paper jam will occur.
Before turning the machine on, check there is no original left on the exposure
glass.
Note
❒ Do not stack originals over the limit mark on the inner side wall of the ADF.
❒ The last page should be on the bottom.
❒ To copy thin originals of 40 to 52 g/m
2
(35 to 45 kg), two or more originals
may be fed at a time, and be damaged. To avoid this, place originals one by
one in the ADF, or place an original on the exposure glass.
A
AA
A
Set the document guide to the original size.
B
BB
B
Align the edges of the original and place it in the ADF with the side to be
copied facing up.
1. Limit mark
2. Document guide
TJAH050E