Filter
Top Products
19UPS Network Management Card 2 User’s Guide
Description: View the status of the network and all active IPv4 and IPv6 addresses.
ntp
Access: Administrator, Device User
Description: View and configure the network time protocol parameters.
Example 1: To enable the override of manual setting, type:
ntp -OM enable
Example 2: To specify the primary NTP server, type:
ntp -p 150.250.6.10
ping
Access: Administrator, Device User
Description. Determine whether the device with the IP address or DNS name you specify is connected to
the network.
Four inquiries are sent to the address.
Example: To determine whether a device with an IP address of 150.250.6.10 is connected to the network,
type:
ping 150.250.6.10
portspeed
Access: Administrator
Description:
Example:
To configure the TCP/IP port to communicate using 100 Mbps with half-duplex communication
(communication in only one direction at a time), type:
portspeed -s 100H
prompt
Access: Administrator, Device User
Option Argument Definition
-OM enable | disable
Override the manual settings.
-p <primary NTP server> Specify the primary server.
-s <secondary NTP server> Specify the secondary server.
Argument Description
<IP address or DNS name>
Type an IP address with the format xxx.xxx.xxx.xxx, or the DNS name configured
by the DNS server.
Option Arguments Description
-s
auto | 10H | 10F |
100H | 100F
Define the communication speed of the Ethernet port. The auto command
enables the Ethernet devices to negotiate to transmit at the highest possible
speed. See “Port Speed” on page 55 for more information about the port speed
settings.