Seagate 100516225 Computer Drive User Manual


 
CHEETAH 15K.7 FC PRODUCT MANUAL, REV. E 34
9.0 DEFECT AND ERROR MANAGEMENT
Seagate continues to use innovative technologies to manage defects and errors. These technologies are designed to
increase data integrity, perform drive self-maintenance, and validate proper drive operation.
SCSI defect and error management involves drive internal defect/error management and FC system error considerations
(errors in communications between the initiator and the drive). In addition, Seagate provides the following technologies used
to increase data integrity and drive reliability:
Background Media Scan (see Section 9.4)
Media Pre-Scan (see Section 9.5)
Deferred Auto-Reallocation (see Section 9.6)
Idle Read After Write (see Section 9.7)
The read error rates and specified storage capacities are not dependent on host (initiator) defect management routines.
9.1 DRIVE INTERNAL DEFECTS/ERRORS
During the initial drive format operation at the factory, media defects are identified, tagged as being unusable, and their
locations recorded on the drive primary defects list (referred to as the “P’ list and also as the ETF defect list). At factory
format time, these known defects are also reallocated, that is, reassigned to a new place on the medium and the location
listed in the defects reallocation table. The “P” list is not altered after factory formatting. Locations of defects found and
reallocated during error recovery procedures after drive shipment are listed in the “G” list (defects growth list). The “P” and
“G” lists may be referenced by the initiator using the Read Defect Data command.
Details of the SCSI commands supported by the drive are described in the Fibre Channel Interface Manual. Also, more
information on the drive Error Recovery philosophy is presented in the Fibre Channel Interface Manual.
9.2 DRIVE ERROR RECOVERY PROCEDURES
When an error occurs during drive operation, the drive, if programmed to do so, performs error recovery procedures to
attempt to recover the data. The error recovery procedures used depend on the options previously set in the Error Recovery
Parameters mode page. Error recovery and defect management may involve using several SCSI commands described in
the Fibre Channel Interface Manual. The drive implements selectable error recovery time limits required in video
applications.
The error recovery scheme supported by the drive provides a way to control the total error recovery time for the entire
command in addition to controlling the recovery level for a single LBA. The total amount of time spent in error recovery for a
command can be limited using the Recovery Time Limit bytes in the Error Recovery mode page. The total amount of time
spent in error recovery for a single LBA can be limited using the Read Retry Count or Write Retry Count bytes in the Error
Recovery mode page.
The drive firmware error recovery algorithms consists of 13 levels for read recoveries and five levels for write. Each level
may consist of multiple steps, where a step is defined as a recovery function involving a single re-read or re-write attempt.
The maximum level used by the drive in LBA recovery is determined by the read and write retry counts.
Table 5 equates the read and write retry count with the maximum possible recovery time for read and write recovery of
individual LBAs. The times given do not include time taken to perform reallocations. Reallocations are performed when the
ARRE bit (for reads) or AWRE bit (for writes) is one, the RC bit is zero, and the recovery time limit for the command has not
yet been met. Time needed to perform reallocation is not counted against the recovery time limit.
When the RC bit is one, reallocations are disabled even if the ARRE or AWRE bits are one. The drive will still perform data
recovery actions within the limits defined by the Read Retry Count, Write Retry Count, and Recovery Time Limit parameters.
However, the drive does not report any unrecovered errors.