Seagate ST9550AG Computer Drive User Manual


 
High-level formatting
High-level formatting verifies the information written by the low-
level format and creates file allocation tables used to catalog and
access files.
1. Run the FORMAT program. Insert a DOS program diskette
containing the FORMAT program into your diskette drive. At
the DOS prompt, type format, followed by the drive letter for
the first drive partition you want to format (for example,
format C:). Then, press
ENTER
. Repeat this procedure to
format each of the new drive partitions you have created.
Consult your DOS manual for FORMAT command options.
Note. If you are formatting the drive partition that will be used to
boot your computer (the “C” drive), copy the DOS system
files to this drive. To do this, type /s after the format
command (for example, format C: /s)
2. Verify the drive capacity. After high-level formatting a drive,
you can verify the usable drive capacity by running the DOS
CHKDSK utility program.
Installation troubleshooting
Before calling Seagate Technical Support, please read and con-
sider all the possibilities discussed on the following pages. The
suggestions presented here address the vast majority of instal-
lation problems.
General troubleshooting procedures
The following is a list of general troubleshooting procedures. Solu-
tions for specific problems are provided on subsequent pages.
Warning. Always turn off the computer before changing jump-
ers, moving cables or touching any internal compo-
nents.
10 ST9655 Family Installation Guide, Rev. A