Filter
Top Products
18
To enter the Setup Menu System and change the settings
1. Lift the window cover of the printer.
2. Eject any paper currently in the printer (or park tractor paper) then switch the printer online.
3. Keep pressing the PARK/LOAD key for 3 seconds.
This starts the Setup Menu System and prints the instructions for using it. The current
setting is underlined.
The print head points to the current selection in the menu.
4. Make a selection from the menu with the keys on the control panel:
Press: To:
PARK/LOAD
Move the print head to the next menu selection. Repeat this until
you get the selection that you want.
LF/FF
Save the setting that is currently indicated by the print head
position, and go to the next menu.
ONLINE
Move to the next menu without altering the current setting.
COPY
Go to the next menu group.
5. When you have made all of your settings (remember that you don’t have to do go all the
way through the menu system), switch the printer off and then turn on again.
Each time you switch the printer on, it uses the new saved settings. Keep the printout of the
menu selections so that you know what the current settings are.
To exit the Setup Menu System
Turn the printer off, and then turn on again.
* New settings of the menu will be stored.
Printing the Current Setting Report
You can use the information in the current report to decide which settings you want to change.
To print the current settings:
1. Turn the printer off.
2. Hold down both the PARK/LOAD and LF/FF keys
3. Turn the printer on.
NOTE
1. You do not have to go all the way through the menu system. Once you have made all
the changes you want, you only need to exit the Setup Menu System by switching off the
printer. When you switch it on again, the printer uses the new settings.
2. When the compress mode is effective, the High Speed mode will not be valid.