Filter
Top Products
Messages and Signals
146
Audible signals
REMOVE /
BYPASS PAPER
(alternating messages)
A fax has been received to memory because paper is
inserted in the bypass tray (faxes cannot be printed
while paper is in the bypass tray). Remove the paper
from the bypass tray to allow the fax to be printed.
SYSTEM ERROR [XX]
(a number appears in
“XX”)
If this message appears, unplug the power cord, wait
about 10 seconds, and then plug it back in. If the
message still appears, unplug the power cord and call
SHARP’s Customer Assistance Center at at 1-877-
794-8675 (U.S.A. only).
SET BYPASS PAPER /
SIZE: XXXX
(alternating messages; a
paper size appears in
“XXXX”)
Paper must be inserted in the bypass tray for a print
job or copy job that requires use of the bypass tray.
Insert the indicated size of paper in the tray.
TONER EMPTY The toner cartridge must be replaced. Printing will be
possible (although the output will be increasingly
faint) until a fax is received. Once a fax is received, it
will be held in memory and printing will not be
possible until the toner cartridge is replaced.
TONER NEAR EMPTY The toner cartridge is almost out of toner
(approximately 200 pages can be printed).
TOTAL PAGE(S) 01 Number of fax pages transmitted or received.
Continuous tone 3 seconds Indicates the end of fax transmission or
reception.
Intermittent tone
(3 beeps)
5 seconds
(1 second on, 1
second off)
Indicates incomplete fax transmission
or reception.
Rapid intermittent
tone
35 seconds
(0.7 seconds on,
0.3 seconds off)
Indicates that an extension phone
connected to the machine is off hook.