Filter
Top Products
22
MAKING COPIES
COPYING FROM THE ORIGINAL TABLE
Copying from the original table
5
Place the second original face down on the original table
and press the START key again to copy onto the other
side.
●
To stop a copy run during duplex copying, press the CLEAR ( ) key.
●
If an uneven number of originals is set, press the ORIGINAL TO
COPY key at the end of the copy run to output the last copy.
●
To cancel the duplex mode, press the ORIGINAL
TO COPY key repeatedly until the indicators in the
ORIGINAL TO COPY section all go out.
●
The image of every front side can be rotated 180°
using the image rotation feature. This feature is
useful when the originals and copies are in the
landscape (horizontal) orientation and the two-sided
copies are to be read by turning them left to right
rather than top to bottom.
To set this feature, follow the procedure below. This
feature can also be set using user program No. 20.
Setting image rotation in duplex copying
1
Press and hold down the ORIGINAL TO COPY key for
approximately 5 seconds until the
indicator will
blink and the currently selected parameter number will
blink in the copy quantity display.
2
Select the desired parameter using the numeric keys.
●
0: OFF 1: ON
The factory default setting is 0.
3
Press the START key.
●
The selected parameter will be steadily lit.
4
Press the ORIGINAL TO COPY key.
●
The indicator will stop blinking.
The image rotation in duplex copying can be also set
using user program No. 20. See page 51.