Filter
Top Products
53
GENERAL INFORMATION
USER PROGRAMS
4
Select the desired parameter using the numeric keys.
●
The entered parameter number will blink on the right side of the copy
quantity display.
●
The parameters are shown in the table below.
For example, to change the setting of the auto power shut-off timer to
60 min., press key 2.
5
Press the START key.
●
The right-hand number in the copy quantity display will be steadily lit
and the entered value will be stored.
6
To continue with other user programs, press the key
and then repeat steps 2 to 5. To exit the user program
mode, press the light ( ) key.
●
All the alarm indicators will go out.
User programs
Program name Parameters
Auto clear time 0 OFF 1 30 sec. * 2 60 sec. 3 90 sec. 4 120 sec.
5
10 sec.
Preheat mode 0 OFF 1 30 sec. 2 60 sec. * 3 90 sec. 4 120 sec.
Auto power shut-off timer * 1 30 min. 2 60 min. 3 90 min. 4 120 min. 5 240 min.
Stream feeding mode * 0 OFF 1 ON
Auto power shut-off setting 0 OFF * 1 ON
Border line for 2 in 1 or 4 in 1 * 0 OFF 1 ON
Rotation copy 0 OFF * 1 ON
Auto paper select mode 0 OFF * 1 ON
Auto tray switching 0 OFF * 1 ON
Erase width adjustment 0 0" 1 1/4" * 2 1/2" 3 3/4" 4 1"
Layout in 2 in 1 copy * 1 Pattern 1 2 Pattern 2
Layout in 4 in 1 copy * 1 Pattern 1 2 Pattern 2 3 Pattern 3 4 Pattern 4
Offset of paper output tray 0 Upper OFF, lower OFF * 1 Upper ON, lower ON
2
Upper ON, lower OFF 3 Upper OFF, lower ON
Image rotation in duplex * 0 OFF 1 ON
copying
Location of the margin * 1 Left 2 Top
Factory default settings are indicated with an asterisk (*). For layout in 2 in 1 copy and 4 in 1 copy, see page 37.
If you select “0” (OFF) in a program, the corresponding
function will be disabled.