Filter
Top Products
53
4
JOB PROGRAM MEMORY
If you frequently use the same settings for copy jobs, you can store in the settings in a job program. Up to 10 job
programs can be stored, and the programs are retained even when the power is turned off. By storing frequently
used copy settings in a program, you can eliminate the bother of selecting the settings each time you use them for a
copy job.
● After a job program is stored, if any settings of the key operator programs related to the stored job program are
prohibited, the related settings in the job program will not be recalled.
● If the overwriting of job programs is prohibited in the key operator programs, it will not be possible to overwrite or
delete a job program.
● To exit job program memory mode, exit the job memory mode, press the [CLEAR ALL] key ( ) on the operation
panel or touch the [EXIT] key on the touch panel.
STORING A JOB PROGRAM
1
Press the [ ] key.
2
Touch the [STORE/DELETE] key.
3
Touch a program number from 1 to 10
in the storage register screen.
4
Select the copy settings that you wish
to store in the program.
The number of copies
cannot be stored.
5
Touch the [OK] key.
The selected settings will
be stored under the
program number
selected in step 3.
If a numeric key is selected that has already
been programmed, a confirmation screen
will appear. To replace the existing program
with the new program, touch the [STORE]
key and continue from step 4. If you do not
wish to replace the existing program, touch
the [CANCEL] key to return to the above
screen and select a different numeric key.
ACC.#-C
S
NUMBER.
ECALL STORE/DELETE
ROGRAMS
SS PROGRAM NUMBER.
RECALL STORE
Note
A4
A3
SPECIAL MODES
2-SIDED COPY
OUTPUT
TO STORE, MAKE SELECTIONS AND PRESS
[OK], TO DELETE, PRESS [CANCEL].
A4
AUTO
EXPOSURE
AUTO A4
PAPER SELECT
100%
COPY RATIO
D PRESS
EL].
CANCEL
A4
A3
OK