Sharp MX-7500N Printer User Manual


  Open as PDF
of 40
 
25
MANUAL FINISHING
Staple
(When a nisher installed)
This function staples the loaded paper sheets into a sheaf.
1 staple in back
1 staple in front
2 Staples
Saddle Stitch
(When a saddle nisher (100-sheet stapling) is installed)
This function staples each set of copies at two positions in the
centre of paper, folds them in half, and outputs them.
(When a trimming module is installed on the saddle nisher)
For saddle stitch, it trims a side drop, offering a good-looking output
image.
Staples each set of copies at two positions
in the centre of paper, and folds them in half
during output
Trims a side drop for saddle folding during
output
Specify the trimming width within the range of
2.0 to 20.0 mm
Folding function
(When a folding unit is installed)
This function folds paper in Z-fold, C-fold, or other types of shapes.
(When a saddle nisher (100-sheet stapling) is installed)
Paper can be folded in a saddle fold.
*
The paper sizes that can be selected vary depending on the type
of paper fold.
*
Specialmediasuchastransparencylmandtabpapercannotbeused.
Allowable paper sizes:
A3W, A3, B4, A4R, SRA3, 12”x18”, 11”x17”,
8-1/2”x14”, 8-1/2”x11”R, 8K
Thefoldsettingscanbeconguredin[Detail].
Allowable paper sizes:
A3, B4, A4R, 11” x 17”, 8-1/2”x14”, 8-1/2”x11”R
This can be used with staple or punch function
only when the A3, B4 or 11"x17" paper is used.
Allowable paper sizes:
A4R, 8-1/2”x11”R
Allowable paper sizes:
A4R, 8-1/2”x11”R
Allowable paper sizes:
A4R, 8-1/2”x11”R
Allowable paper sizes:
A4R, 8-1/2”x11”R
Setting the number of
copies (number of pages)
This function loads previously sorted sheets and outputs multiple
sets at once.
Number of copies setting
Enter the number of output copies
(from 1 to 999)
Number of pages setting
Select this to set all pages as one set
*
If this setting is enabled, set the [Number
of Copies] to "1".
Select this to specify the number of page for
each set
Enter a numeric value when [Manual] is
selected.
(from 1 to 200 pages)
Checking and changing
the output tray
The output tray is automatically selected based on the output
function you set. If Z-Fold, Half Fold, or Punch is selected, however,
you can select the middle or offset tray for the output tray.
If you have changed the output tray, the output function may be
deselected depending on the original output settings.
Selects the middle tray as the output tray
Selects the offset tray as the output tray
Punch function
(When a punch module is installed)
This function punches holes in paper. It is available for paper sizes B5R to A3.
YoucannotuseA3W(12”x18”)sizepaper,andspecialmediasuchastransparencylmandtabpapers.
Punches holes during output
If the paper size used is A3, B4 or 11”×17”, this function can be used with saddle stitch or folding function for Z-fold.
 previous next