Filter
Top Products
-29
Setting of Search Port
(ADVANCED[0]Search Port)
Sets the port number used when searching
for the projector from the network.
advanced>0
Please Enter Port Number for Search from Computer.
Valid range : 1025 to 65535
Search Port : 5006
Please Enter : 5004
(change) —> 5004
1
2
*
1 Enter “0” and press the “Enter” key.
2 Enter numerical value and press the
“Enter” key.
Display set numerical value (*).
Set according to need. Normally, use with the
factory default setting.
•
Note
Return to Default Settings
(ADVANCED[!]Restore Default
Setting)
Returns all menu setting values to the default
state.
advanced>!
Restore All Setting to Default(y/n)? y
— User Setting Initialized —
1
2
1 Enter “!” and press the “Enter” key.
2 Enter “y” and press the “Enter” key.
If the values for IP Address, Subnet Mask or
Gateway of the projector have been returned to
the default settings via Telnet, the computer
cannot be connected to the projector
depending on the computer's network settings.
•
Note
Setting up the Projector Using RS-232C or Telnet
Return to Main Menu
(ADVANCED[Q]Return to Main
Menu)
Returns to the main SETUP MENU.
advanced>q
----------------------------SETUP MENU---------------------------
[1]IP Address [2]Subnet Mask [3]Default Gateway
[4]User Name [5]Password
[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client
[A]Advanced Setup [D]Disconnect All
[V]View All Setting [S]Save & Quit [Q]Quit Unchanged
setup>
1
1 Enter “q” and press the “Enter” key.
Returns to the SETUP MENU.