Filter
Top Products
US
44
■ If execution of the command is taking some time.
W
Carriage return code
(0D
H, 0AH)
A I T ↵
If execution of a command takes some time, WAIT may be returned as the returned value. In this
case, a value will be returned if you wait a while. During this time, new commands will not be
received, even if they are sent.
No ID number is attached to WAIT response.
LOC K
ED
↵
Carriage return code
(0D
H
, 0A
H
)
T
Carriage return code
(0D
H
, 0A
H
)
I M E O U
T
↵
Carriage return code
(0D
H, 0AH)
TIM E O U
T
0 0 1
↵
SPC
Space (20H)
• Cases where WAIT is returned
1. When repeater control is used
2. When an IDSL or IDLK command is used
3. When one of the following commands is used: RSET, INP1, INP2, INP3, INPC, INPS, ITGD,
IAVD, IPCD, CLSY, ASNC, WIDE, EMAG, EPOS, PXSL, POWR
PC Operation (Continued)
■ When control via RS-232C is locked (to prevent use) using the Control lock function (see page 54).
■ If a timeout occurs while waiting for a command
■ If a timeout occurs while waiting for a command (when the monitor waiting for the command is
assigned an ID number = 001 in the following example)
■ If the current parameter is read out using "?" for the parameter (for numerical values etc.)
1Response when no ID number has been set.
<Example> VOLM????
10
2Response when an ID number has been set. (In the example below: ID=001)
<Example> VOLM????
10 001