Sharp PG-M20X Projector User Manual


 
Setting the Anti-Theft (cont.)
When Anti-Theft is set, the keycode
inputting section appears after the
power is turned on. At that time, enter
the right keycode.
Press the buttons on the remote control if
the buttons on the remote control are used
for setting the keycode. In the same manner,
press the buttons on the projector if the
buttons on the projector are used for setting
the keycode.
Info
Once the function is activated, you must
remember the correct keycode. We
suggest you record the keycode in a safe
place where only authorized users will
have access. If you lose or forget your
keycode, you will need to contact your
nearest Sharp Authorized Projector Dealer
or Service Center (see page 78). You may
need to bring your projector to them to
restore the projector to original factory
condition (password and keycode reset).
Changing the Keycode
When Anti-Theft is selected, the password
input box is displayed. After the password has
been entered, you can change the keycode.
Select Anti-Theft in the Options (2)
menu For details, see page 38.
1 Press the buttons on the
remote control or the projector
to enter the preset 4-digit
keycode in Old Code.
2
Press any button you like on the
remote control or the projector
to enter the new keycode.
3 Enter the same 4-digit keycode
in Reconfirm.
Note
If you do not want to set a keycode, leave
the keycode field blank in steps 2 and 3
and press
.
-64