Filter
Top Products
ENGLISH
12
TROUBLESHOOTING
PROBLEM SOLUTION
No sound at the receiver n Check the power cord on the TransMixer and make sure it is
powered on.
n Make sure both the TransMixer and the P2R Receiver are set to
the same frequency channel.
n Make sure the earphones are plugged in to the receiver and the
volume is up.
n Make sure the Receiver is on and the battery is good.
n Check the incoming audio connections on the TransMixer.
Low receiver range n Try to maintain line-of-sight between the TransMixer and Receiver
antennas.
n Try another frequency in case interference is limiting the range.
n Check for television channel interference. More information is
available at www.shure.com.
Receiver sounds fuzzy or distorted n Make sure no other TransMixers or wireless transmitters are oper-
ating on your frequency.
n Make sure the TransMixer input level is lighting yellow LEDs for
optimum performance.
n Make sure you are using a fresh battery in the P2R.
Low audio output at the receiver n Make sure the TransMixer input level is lighting yellow LEDs for
optimum performance.
n Make sure the P2R Receiver’s volume knob is up.
ACCESSORIES
Furnished Accessories
P2T TransMixer
AC Adaptor PS20, PS20E, PS20UK. . . . . . . . . . . . . . . . . . . . .
Single Mount Rack Bracket 53A8484. . . . . . . . . . . . . . . . . . . . .
Dual Mount Rack Bracket 53B8484. . . . . . . . . . . . . . . . . . . . . .
Straddle Bars 53A8443. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Hardware Kit 90AD8100. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
P2R Receiver
1/4-inch mono 20 foot cable 90B4677. . . . . . . . . . . . . . . . . . .
Optional Equipment
AuxPander:
The Shure AuxPander auxiliary expander extends the capabili-
ties of a standard mixing console by providing eight additional
auxiliary sends. It is designed ideally for use with multiple per-
sonal monitoring systems.
P4M:
The P4M is a highly versatile four–channel, two–bus stereo
mic/line mixer designed to optimize personal (in–ear) monitor
systems in live performance applications.
SPECIFICATIONS
PSM200 System
RF Carrier Frequency Range
518–865 MHz (country dependent)
Operating Range
100 m (300 ft.) under optimal conditions
Audio Frequency Response
30 Hz to 12 kHz (+/–3 dB); earphone dependent
Total Harmonic Distortion (1 kHz)
<1% typical (Ref. ±35 kHz deviation)
Modulation
FM ±35 kHz Deviation (Nominal)
Signal-to-Noise Ratio
80 dB typical (A-weighted)
Operating Temperature
–7° C to +49° C
(+20° F to +120° F)
P2T TransMixer
RF Output Power
30 mW (+15 dBm) typical conducted (country dependent)
Modulation Limiter
Internal peak limiter (>10:1 hard knee compression)
Antenna
1/4 Wavelength, semi-rigid, PCB Mount
Current
170 mA maximum
Dimensions
220 mm x 140 mm x 40 mm (8.6 in. x 5.6 in. x 1.7 in.)
Net Weight
370 g (13 oz.)