Support User Manuals

Sierra Wireless 20070914 Network Router User Manual

Open as PDF

of 176

Raven 1x

121 20070914

Caution: While the modem is in PassThru mode, ALEOS is disabled.

If you need to connect to the Raven while it is in PassThru mode, you

will need to do so with a terminal application. Not all commands are

available while the modem is in PassThru mode.

Figure 1-10: AceManager : PassThru

\APASSTHRU

Note: This mode is not available

through the remote AT telnet

server. You will need to connect

to the Raven with it connected

directly to your computer.

Setsthemodemoperationtopassthroughmode.Thismode

willpassanycharactersreceivedontheportEthernetdirectly

totheinternalhardwaremoduleandoutputanycharacters

fromtheinternalhardwaremoduleouttheportEthernet.This

allowsdirectaccess/configurationofthehardwaremodule.

Oncethismodeisentered,

theunitmustbephysicallyresetto

returntonormaloperation.Thiscommandisnotavailablein

AceManager.

Note: It may take up to 30 seconds for the hardware module to

respond after CONNECT is output.

*CSX1=n

PassThruEcho:Echodatatothe host.

• n=0:Datawillbepassedtothehost.

• n=1:PASSTHRUmodewillechoallhostreceiveddata

andwillnotpassthedatatothemodemwhilethemodem

isnotassertingDCD.

Note: If the modem is asserting DCD, data will be passed from the

host to the modem as it normally is when *CSX1=0.

*PTINIT=string

AnyATCommandstringtobepassedtotheOEMmodule

beforeenteringPASSTHRUmode,e.g.AT&S1V1,etc.

• string=ATcommand(s)

previous next