Filter
Top Products
WA_DEV_W218_PTS_002 Rev 005 Page 87 of 109
Product Technical Specification &
Customer Design Guidelines
Software Configurations
This section discusses the software configuration for the equipment(s) used and the WISMO218
settings.
WISMO218 Configuration
The WISMO218 software configuration is simply performed by selecting the operating mode to be
used to perform the measurement.
A description of the operating modes and the procedure used to change the operating mode are given
in the appendix of document [2] WISMO218 AT Commands Manual.
An overview of the WISMO218 operating modes is given below:
OFF Mode
Alarm Mode
Idle Mode
Connected Mode
Transfer Mode class 8 (4Rx/1Tx) (in GPRS mode)
Transfer Mode class 10 (3Rx/2Tx) (in GPRS mode)