Filter
Top Products
6-3
6.1.2 Recommended Screws
Recommended mounting screws are as follows:
c JIS B1111 M2.6 and M3 Cross-Recessed Head Machine screw
d Small P Tight 2.6 screw for resinated material
6.1.3 Precautions for Securing the Printer
Pay attention to the following when securing the printer. Failure to follow these instructions may cause
deterioration of print quality, paper skew, paper jam, noise or damage.
z Prevent excessive force or torsion when securing the printer.
z Mount the printer on the flat mounting face and use the printer in a place where vibration does
not occur. A rubber vibration isolator is also effective to prevent vibration.
z Connect both U shaped gutters c to FG (Frame Ground) on the circuit board with metal
screws to prevent damage to the thermal head due to static electricity.
z Make equipotential between FG and signal ground by connecting both with an approximately 1
MΩ resistor.
z Do not damage the lead wires when securing the printer with screws.