Filter
Top Products
6-6
6.5 WHERE TO MOUNT THE PLATEN RELEASE KNOB
The platen release knob fitted to the outer case can be installed by using the outer shape of the
release lever and three holes. CHAPTER 7 shows the appearance and the positions of the holes.
Do not apply a force of 29.4 N (3 kgf) or more to the release lever. Doing so may cause
deformation and malfunction of the lever.
6.6 WHERE TO MOUNT THE PAPER CUTTER
Design the layout of the autocutter so that it does not interfere with the paper feed. The position for
feeding out paper is shown in CHAPTER 7 APPEARANCE AND DIMENSIONS.
z If the distance between the edge of the thermal head and the edge of the fed paper is too
small, the paper may be caught in the platen. Please take this into account when designing
the outer case.
z Use a cutter with a sharp edge so that paper is cut with the paper hold force or less.