Filter
Top Products
These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode or when the source is disconnected. See Value-based command
methods on page 58 for setting absolute and adjustment commands.
Command Command target range Response
set displaymode [target] =SMART Presentation
=Bright Classroom
=Dark Classroom
=sRGB
=User
displaymode=[target]
set brightness [value] =0 to =100 brightness=[value]
set contrast [value] =0 to =100 contrast=[value]
set whitepeaking [value] =0 to =10 whitepeaking=[value]
set degamma [value] =0 to =3 degamma=[value]
set red [value] =0 to =100 red=[value]
set green [value] =0 to =100 green=[value]
set blue [value] =0 to =100 blue=[value]
set cyan [value] =0 to =100 cyan=[value]
set magenta [value] =0 to =100 magenta=[value]
set yellow [value] =0 to =100 yellow=[value]
set videofreeze [target] =on
=off
videofreeze=[target]
Additional VGA source controls
Your VGA source supports all the general source controls described in General source controls on
previous page, as well as the commands listed in this section. These settings are unavailable when
the projector is in Standby mode or when the VGA sources are disconnected.
N N OTE
Some of these commands are invalid with composite video sources.
These commands inform you of the current VGA source settings.
Command Response
get frequency frequency=[current frequency setting]
get tracking tracking=[current tracking setting]
get saturation saturation=[current saturation setting]
get tint tint=[current tint setting]
get sharpness sharpness=[current sharpness setting]
A PPEN D IX A
Remotelymanagingyour interactive whiteboardsystem
62