Filter
Top Products
These commands inform you of the current audio output settings.
Command Response
get volume volume=[current volume setting]
get mute mute=[current mute setting]
get volumecontrol volumecontrol=[current volume control setting]
get cc cc=[current closed captioning language setting]
These commands control your audio output settings. See Value-based command methods on page
58 for setting absolute and adjustment commands.
Command Command target range Response
set volume [value] =0 to =40 volume=[value]
set mute [target] =on
=off
mute=[target]
set volumecontrol [target] =on
=off
volumecontrol=[target]
set cc [target] =cc1
=cc2
=off
cc=[target]
N N OTE
Typically, cc1 displays American English subtitles, while cc2 displays other regional languages,
such as French or Spanish, depending on television channel or media setup.
Network controls
These commands control your projector’s network status and settings. These settings are available
even when the projector is in Standby mode. You must locally set the network and VGA out
commands to on, which is located in the OSD for the network abilities to work.
These commands inform you of the current network settings.
Command Response
get netstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
get dhcp dhcp=[current DHCP status]
get ipaddr ipaddr=[current IP address]
get subnetmask subnetmask=[current subnet work mask number]
get gateway gateway=[current network gateway]
get primarydns primarydns=[current primary domain name number]
get macaddr macaddr=[current MAC address]
A PPEN D IX A
Remotelymanagingyour interactive whiteboardsystem
64