Filter
Top Products
C
ONFIGURING
THE
S
WITCH
2-92
CLI – The following example enables LACP for ports 17 and 18. Just
connect these ports to two LACP-enabled trunk ports on another switch
to form a trunk.
Statically Configuring a Trunk
Command Usage
• When configuring static trunks, you may not be able to link switches
of different types, depending on the manufacturer’s implementation.
The static trunks on this switch are Cisco EtherChannel compatible.
• To avoid creating a loop in the network, be sure you add a static trunk
via the configuration interface before connecting the ports, and also
disconnect the ports before removing a static trunk via the
configuration interface.
Console(config)#interface ethernet 1/17 3-85
Console(config-if)#lacp 3-168
Console(config-if)#exit
Console(config)#interface ethernet 1/18
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1 3-95
Information of Trunk 1
Basic information:
Port type: 1000t
Mac address: 22-22-22-22-22-2d
Configuration:
Name:
Port admin status: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full,
Flow control status: Disabled
Port security: Disabled
Port security action: None
Current status:
Created by: Lacp
Link status: Up
Port operation status: Up
Operation speed-duplex: 1000full
Flow control type: None
Member Ports: Eth1/17, Eth1/18,
Console#