Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
3-64
Example
Related Commands
snmp-server host (3-61)
snmp ip filter
Sets the IP addresses of clients that are allowed management access to the
switch via SNMP. Use the no form of this command to remove an IP
address.
Syntax
snmp ip filter ip_address subnet_mask
no snmp ip filter ip_address subnet_mask
• ip_address - An IP address indicating a client or group of clients that
are allowed SNMP access to the switch.
• subnet_mask - An address bitmask of decimal numbers that represent
the address bits to match.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• You can create a list of up to 16 IP addresses or IP address groups that
are allowed access to the switch via SNMP management software.
• Address bitmasks are similar to a subnet mask, containing four decimal
integers from 0 to 255, each separated by a period. The binary mask
uses “1” bits to indicate “match” and “0” bits to indicate “ignore.”
• If the IP is the address of a single management station, the bitmask
should be set to 255.255.255.255. Otherwise, the IP address group is
Console(config)#snmp-server enable traps link-up-down
Console(config)#