Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
3-58
Example
SNMP Commands
Controls access to this switch from SNMP management stations, as well as
the error types sent to trap managers.
snmp-server community
Use this command to define the community access string for the Simple
Network Management Protocol. Use the no form to remove the specified
community string.
Console#show tacacs-server
Remote TACACS server configuration:
Server IP address: 10.11.12.13
Communication key with radius server:
Server port number: 49
Console#
Command Function Mode Page
snmp-server
community
Sets up the community access string to
permit access to SNMP commands
GC 3-58
snmp-server contact Sets the system contact string GC 3-60
snmp-server location Sets the system location string GC 3-60
snmp-server host Specifies the recipient of an SNMP
notification operation
GC 3-61
snmp-server enable
traps
Enables the device to send SNMP
notifications (i.e., SNMP traps)
GC 3-63
snmp ip filter Sets IP addresses of clients allowed to
management access to the switch via
SNMP
GC 3-64
show snmp Displays the status of SNMP
communications
NE,
PE
3-65