Filter
Top Products
P
RIORITY
C
OMMANDS
3-151
switchport priority default
Use this command to set a priority for incoming untagged frames, or the
priority of frames received by the device connected to the specified
interface. Use the no form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
Default Setting
The priority is not set, and the default value for untagged frames
received on the interface is zero.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Precedence or IP DSCP, and
default switchport priority.
Layer 3 and 4 Priority Commands
map ip precedence Enables IP precedence class of service
mapping
GC 3-156
map ip precedence Maps IP precedence value to a class of
service
IC 3-157
map ip dscp Enables IP DSCP class of service mapping GC 3-158
map ip dscp Maps IP DSCP value to a class of service IC 3-159
show map ip
precedence
Shows the IP precedence map PE 3-160
show map ip dscp Shows the IP DSCP map PE 3-161
Command Function Mode Page