Soho NBG800 Network Router User Manual


 
SOHOware
®
Secure Cable/DSL Router 5
Chapter 2: Installation
What You Need
Before installing the SOHOware BroadGuard you need the following:
Any Network Operating System with:
TCP/IP installed
Internet browser installed
10Mbps/100Mbps or 10/100Mbps Ethernet network adapters installed
Broadband Internet Account
You should be subscribed to a broadband Internet service and have a cable/DSL
modem with a 10Base-T interface. Know whether your Public IP address is fixed
or is dynamically assigned (ask your Broadband Service Provider).
1. If your IP address is dynamically assigned (most common), the BroadGuard
will automatically get a public IP address from your ISP through the modem.
You will not need to do any IP address configuration.
There is no need to enter any information in Broadband Connection unless
your BSP has assigned you specific Internet connection information (Host
Name, Domain Name, MAC address authentication, PPPoE, or a static IP
address).
To do a manual setup, type 192.168.1.1 into the web address location on a
web browser on any connected PC. Enter the factory default user name
admin and password 1234. After clicking OK you will enter the setup home
page. Click the Broadband Connection link to begin setup of the broadband
connection.
2. If you have an AT&T (formerly MediaOne) cable service, or any service that
requires a Media Access Control (MAC) address for authentication, when you
are setting up the BroadGuard for first use, only the PC with the registered
Ethernet card’s MAC address can be connected to the BroadGuard.
3. If you have a DSL service with PPPoE, obtain the following information from
your BSP:
The user login name
The login password
Service name (some BSPs may not require you to use this)