Filter
Top Products
28 (GB)
Note
If you use the wide zoom mode, it is recommended
that you set the H SIZE, H SHIFT, V SIZE and V
SHIFT to the standard (00) . If you change them too
much, the wide zoom display may be distorted. Before
you use the wide zoom mode, set ZOOM to ×1. If
ZOOM is set to ×2, ×3 or ×4, the wide zoom mode
cannot be used.
Adjusting the Pixels
If there is too much noise on the edges of the
characters or the vertical lines, you can adjust the dot
phase and total number of horizontal pixels.
1 Press MENU.
The main menu appears on the monitor screen.
ENTER
MENU
MA IN MENU
PIC CONTROL
PIC SIZE
CONF IG
MEMORY
REMOTE
STATUS
SELECT SET END
2 Press M/m to move the cursor (B) to “PIC SIZE”
and press ENT.
The PIC SIZE menu appears on the monitor
screen.
ENTER
MENU
PIC SIZE
HSIZE : 00
HSHIFT : 00
VSIZE : 00
VSHIFT : 00
RESET
ASPECT : 4X3
ZOOM : X1
PIXEL ADJUST
SELECT SET END
3 Press M/m to move the cursor (B) to “PIXEL
ADJUST” and press ENT.
The following menu appears on the monitor
screen.
ENTER
MENU
PIXEL ADJUST
AUTO
DOT PHASE : 50
TOTAL H PIXEL : 800
RESET
SELECT SET END
4 You can adjust the dot phase and total number of
horizontal pixels automatically or manually.
Adjusting automatically
(1) Select AUTO with M/m and press ENT.
The following menu appears on the monitor
screen.
ENTER
MENU
PIXEL ADJUST
AUTO : NO
SELECT SET END
(2) Select YES with M/m and press ENT.
The dot phase and total number of horizontal
pixels are adjusted automatically.
Adjusting manually
(1) Select DOT PHASE or TOTAL H PIXEL
with M/m and press ENT.
The following menu appears on the monitor
screen. (The illustration below is for selecting
the DOT PHASE.)
DOT PHASE : 50
Resizing and Positioning the Picture / Adjusting the Pixels