Filter
Top Products
Operation
26
Camera View Operations
4 [ALARM] Button
Clicking this button changes the monitor screen to the
Alarm mode, which allows searching images or
replaying video when an alarm has occurred. Refer to
“Viewing Alarm Event Images” on page 29 for details.
5 [ALARM MEMORY] Indicator
Images acquired when alarm events occur are stored in
the memory of the video network station. The amount
of available memory is indicated in seven steps from
“E” (empty) to “F” (full).
6 Users Logged On
Shows the number of users logged on to the video
network station. The value for the number of users
logged on is only an approximation.
7 [HOME] Button
Returns the video camera to the home position.
The Camera View displays the video camera images.
Use the screen buttons and icons to switch between
cameras and display modes.
1 [ALL] Button
Clicking this button switches the monitor screen to the
ALL mode (as shown in the above example). In this
mode, images from the video cameras connected to the
video network station are displayed in two or four
partitions.
2 [CAM1] to [CAM4] Buttons
Clicking one of these buttons changes the monitor
screen to the Single mode, in which only one video
camera image is displayed. Each button corresponds to
one of the video input terminals (“VIDEO 1” to
“VIDEO 4”) on the video network station. Buttons
corresponding to disabled video input terminals are not
displayed.
3 [SEQ] Button
Clicking this button changes the monitor screen to the
Sequential mode, in which the image from each video
camera is displayed one at a time, switching from one
camera to the next at preset intervals.
1
3
4
5
6
7
8
9
0
qa qs
2
qd
qf