Filter
Top Products
11 (GB)
5 INPUT key
Selects the input signal. Each time you press the key,
the input signal switches as follows:
INPUT C is not displayed when INPUT C FUNC. is
set to OFF in the INSTALL SETTING menu.
6 APA (Auto Pixel Alignment) key
Adjusts a picture to be projected clearest
automatically while a signal from the computer is
input. Adjusts the shift (up/down and left/right) at the
same time automatically. (Only when inputting a
RGB (analog) signal from the computer).
Note
Press the APA key when the full image is displayed
on the screen. If there are black edges around the
image, the APA function will not function properly
and the image may extend beyond the screen.
7 MENU key
Displays the on-screen menu. Press again to clear the
menu.
8 ENTER key
Enters the settings of items in the menu system.
9 RESET key
Resets the value of an item back to its factory preset
value. This key functions when the menu or a setting
item is displayed on the screen.
Location and Function of Controls
3 Indicators
TEMP (Temperature)/FAN
• Lights up when temperature inside the projector
becomes unusually high.
• Flashes when the fan is broken.
LAMP/COVER
• Lights up when the lamp has reached the end of
its life or becomes a high temperature.
• Flashes when the lamp cover or air filter is not
secured firmly.
POWER SAVING
Lights up when the projector is in the power
saving mode. When POWER SAVING in the
SET SETTING menu is set to ON, the projector
goes into the power saving mode if no signal is
input for 10 minutes. Although the lamp goes out,
the cooling fan keeps running. In the power
saving mode, any key does not function for the
first 40 seconds. The power saving mode is
canceled when a signal is input or any key is
pressed.
ON/STANDBY
• Lights in red when the AC power cord is
plugged into the wall outlet. Once in the
standby mode, you can turn on the projector
with the
I / 1
key.
• Lights in green when the power is turned on.
• Flashes in green while the cooling fan runs after
turning off the power with the
I / 1
key. The
fan runs for about 120 seconds after turning off
the power.
The ON/STANDBY indicator flashes quickly
for the first 40 seconds. During this time, you
cannot turn the power back on with the
I / 1
key.
For details on the LAMP/COVER and the TEMP/FAN
indicators, see page 33 (GB).
4
I
/
1
(
on / standby
)
key
Turns on the projector when the projector is in the
standby mode. The ON/STANDBY indicator lights in
green when the power is turned on.
When turning off the power, press the I /
1
key
twice following the message on the screen, or press
and hold the key for about one second.
For details on steps for turning off the power, see “To turn
off the power” on page 20 (GB).
B INPUT-A B INPUT-B B INPUT-C
S-VIDEO b VIDEO b