Filter
Top Products
39
The Installation Menu
Adjustments and Settings Using a Menu
• Since the V keystone function is an electronic correction, sometimes the image will be
deteriorated.
• Depending on the picture position adjusted with the lens shift feature, the aspect ratio of the picture
may change from the original or picture distortion may occur with V Keystone adjustment.
• When both Blanking and V Keystone are adjusted at the same time, Blanking may not function
properly. When you use Blanking, set the V Keystone to “0.”
• Since the displayable area becomes narrower when Blanking value is adjusted, information
necessary on Input-E may not be displayed.
ID Mode Assigns an ID number (1 to 3) to the projector when you
want control two or more projectors individually with the
supplied Remote Commander. When this item is set to “1,”
you can control the projector with the Remote Commander
with the ID MODE key set to “1.” When it is set to “All,”
you can control all the projectors with the Remote
Commander independently of the ID MODE keys of the
Remote Commander.
All
Illumination Selects whether the SONY logo on the top panel of the
projector lights when the projector is on.
On
Direct Power On Set to “On” if you are using a circuit breaker to turn the
power on/off the entire system. You can turn the power on/
off without pressing the
?/1 key on the projector.
Off
Blanking Adjust the displayable area within the four directions of the
screen.
Select each screen edge “left / right / up / bottom” on the
Blanking adjustment screen with M / m key. Adjust the
desired Blanking value with < / , key.
0
Setting items Functions Initial setting
Notes