Filter
Top Products
30 BIOS Setup
HDD Power Down When the set time has elapsed, the BIOS sends
a command to the HDD to power down, which
turns off the motor. Time is adjustable from 1
to 15 minutes. The default setting is Disabled.
Some older model HDDs may not support this
advanced function.
VGA Active
Monitor
Choose Enabled (default) or Disabled.
Enabled Ð enables the power management
timers when a Òno activityÓ event
is detected.
Soft-Off by POR-
BTTN
Choose Instant-off or Delay 4 Sec (default).
Delay 4 Sec turns off the system power 4
seconds after pushing the power button
CPU Fan Off In
Suspend
Choose Enabled to stop the CPU fan when the
system runs into the suspend mode (refer to
Power Management Setup.)
Resume by Ring Choose Enabled or Disabled (default). This
function only works when the computer is
powered on.
Enabled Ð The system will resume active
when modem is ringing.
Disabled Ð The system will not resume when
modem is ringing.
Resume by Alarm Choose Enabled or Disabled (default).
Enabled Ð Set alarm to wake up the system
either by the date (1-31) or time
(hh:mm:ss), and if the date is set to
0, it means that the system will
wake up by the alarm everyday.
Disabled Ð The system ignores the alarm.
IRQ8 Clock Event Choose Enabled or Disabled (default). Alarm
function will be activated when this function is
enabled.
IRQ[3-7,9-15], NMI Choose Enabled (default) or Disabled. The
BIOS monitors these items for activity. If
activity occurs from the Enabled item the
system wakes up.