Filter
Top Products
36 BIOS Setup
IR Transmission Delay Choose Enabled (default) or Disabled.
Due to the various design of IR devices,
transmission delay has to be added on
for different protocol.
IR IRQ Select Choose IRQ3, IRQ4 (default), IRQ10, or
IRQ11. If you have IRQ conflict
problem during using the IR device,
select another IRQ then try again.
FIR Mode Use DMA Choose Disabled, 0, 1, or 3. When you
choose FIR in IR Mode, you need to
select a DMA channel to make the FIR
transmission work.
Onboard Parallel Port Choose the parallel port I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5, or Disabled to disable this
port.
Parallel Port Mode Choose ECP+EPP (default), SPP, EPP,
or ECP. The mode depends on your
external device that connects to this port.
ECP Mode Use DMA Choose DMA3 (default) or DMA1.
This setting only works when the
Onboard Printer Mode is set at the ECP
mode.
EPP Mode Select Choose EPP1.9 (default) or EPP1.7.
Check with your parallel port device
provider to select the right mode.
3. After you have finished with the Integrated Peripherals, press the
<ESC> key and follow the screen instructions to save or disregard
your settings.