Hardware Setup SY-6ZB
24
Step 14. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Clear CMOS Data Retain CMOS Data
JP5
Setting
Short pin 2-3 for
at least 5 seconds
to clear the CMOS
Short pin 1-2
to retain new
settings
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
Step 15. Power-On by Keyboard Jumper (JP50)
You can choose to enable the Power-On by Keyboard function by
shorting pin 1-2 on jumper JP50, otherwise, short pin 2-3 to disable
this function.
Power-On by
Keyboard
Enable Disable
JP50 Setting
Short pin 1-2 to enable
the Power-On by
Keyboard function.
Short pin 2-3 and the
Power-On by Keyboard
function is disabled.
Note: When using the Power-On by Keyboard function,
please make sure the ATX power supply can take at least
720mA load on the 5V Standby lead (5VSB) to meet the
standard ATX specification.
3
2
1
3
2
1
3
2
1
3
2
1