Filter
Top Products
BIOS Setup Utility SY-7ISA+
80
PNP/PCI Configuration Setup (Continued)
PNP/PCI
Setup
Setting Description Note
How to set the BIOS to release the IRQ to the PnP Interrupt pool:
Interrupt
Line
PnP / PCI configuration Integrated Peripherals
IRQ 15 IRQ 15: PCI / ISA PnP On-Chip Secondary PCI IDE: disabled
IRQ 14 IRQ 14: PCI / ISA PnP On-Chip Primary PCI IDE: disabled
IRQ 12 IRQ 12: PCI / ISA PnP
Interrupt 12 will be released by the PnP
BIOS automatically if the PS/2 Mouse Port
is not used.
IRQ 7 IRQ 7: PCI / ISA PnP Onboard parallel port: disabled
IRQ 4 IRQ 4: PCI / ISA PnP Onboard Serial port 1: disabled
IRQ 3 IRQ 3: PCI / ISA PnP Onboard Serial port 2: disabled
4. Your OS may reassign another interrupt to a PCI slot after BIOS passes control
to the OS, especially if you use Windows 95, 98 or NT.
Disabled BIOS will assgin IRQ for USB port.
Assign IRQ
For
VGA/USB
Enabled BIOS won’ t assign IRQ for USB
port.
Default
5. Your OS may reassign another interrupt to a PCI slot after BIOS passes control
to the OS, especially if you use Windows 95, 98 or NT.
INT Pin
1/2/3/4
Assignment
Auto Set to Auto the BIOS will using
IRQs Automatically.
Default
3-7.2 MULTI I/O ADDRESSES
Default settings for multi-I/O addresses are as follows:
Port I/O Address IRQ Status
LPT1
378H 7 ECP/EPP
COM1
3F8H 4
COM2
2F8H 3
Warning: If a default I/O address conflicts with other I/O cards
such as sound card, you must change one of the I/O addresses to
remedy to this address conflict. (I/O addresses can be adjusted from
the BIOS Setup Utility)