Filter
Top Products
SPECTRA SERIES 37
8.5.2 ADEMCO EXPRESS
The Ademco Express is a high-speed reporting format, which will transmit the 2-digit (11 to FF) report
codes programmed into sections [160] to [213]. Unlike other Ademco formats, the Ademco Express does
not use the Contact ID Report Codes.
8.5.3 ADEMCO CONTACT ID
Ademco Contact ID is a fast communicator format that uses tone reporting instead of pulse reporting. This
communicator format also uses a pre-defined list of industry standard messages and report codes that will
suit most of your basic installation needs. Please refer to the Contact ID Report Codes List in the
Programming Guide for a complete list of these report codes and messages.
8.5.4 CONTACT ID OPTIONS
Section [136]: Dialer Options
Option [3] OFF = Programmable Codes
Option [3] ON = All Codes (default)
When using the Programmable Codes format, use the Ademco Contact ID Report Codes List in the
Spectra System Programming Guide (version 2.0 or higher) to program the desired report codes into
sections [160] to [213]. Enter FF to use the default Contact ID Report Codes. Press the [
FORCE] key to
enter a 0 value. When using the All Codes format, the control panel will automatically generate Contact ID
Report Codes for every event in sections [160] to [213]. Refer to the “All Codes” Ademco Contact ID
Report Code List in the Spectra System Programming Guide.
When using the Ademco Contact ID Programmable format, both telephone numbers must
use this reporting format.
8.5.5 PAGER REPORTING FORMAT
Section [136]: Dialer Options
[6] OFF / [7] OFF: 1 call to the pager/cellular telephone
[6] OFF / [7] ON: 2 calls to the pager/cellular telephone
[6] ON / [7] OFF: 3 calls to the pager/cellular telephone
[6] ON / [7] ON: 4 calls to the pager/cellular telephone
Using this format allows the control panel to transmit report codes to a pager or a cellular telephone. Since
the control panel cannot confirm whether the transmission was successful or not, it can be programmed to
call the pager or cellular telephone up to four times and transmit the report codes each time. To ensure that
the report is received, the control panel transmits the account number, the report code and the # sign four
times during each call. Also, refer to the Pager Delay in section 8.6.
8.6 PAGER DELAY
Section [083]
001 to 255 seconds, default = 5 seconds
When using the Pager Reporting Format (see section 8.5.5), the control panel will wait for the Pager Delay period
before transmitting the report codes. This is to allow time for the pager system to provide a dial tone or to bypass the
“welcome” message before sending data.