Filter
Top Products
SPECTRA SERIES 55
12.14 PROGRAMMING CHIME ZONES
Users can program which zones will be Chime Enabled. A Chime Enabled zone will cause the keypad to emit a
rapid intermittent beep tone (
BEEP-BEEP-BEEP-BEEP) advising the user every time it is opened. Each keypad must be
Chime Programmed separately.
10-ZONE LED KEYPAD:
Press and hold any key from [1] to [10] for 3 seconds to activate or deactivate Chiming for zones 1 to 10. For
example, press and hold the [1] key to enable chiming on zone 1. If after pressing and holding a key, the keypad
emits a confirmation beep, this means the chime feature has been enabled for that zone. If the keypad emits a
rejection beep, this means the chime feature has been disabled for the corresponding zone.
16-ZONE LED KEYPAD:
Press and hold the [9] key. Enter the 2-digit (01 to 16) zone number(s). When the corresponding LED is on, the zone
is chimed. When the corresponding LED is off, the zone is unchimed. When the desired zones are chimed, press
[
ENTER].
LCD KEYPAD:
Press and hold the [9] key. Enter the 2-digit (01 to 16) zone number(s), or use the arrow keys to scroll through the
zones. and when the appropriate zone is displayed, press the [
FNC1] key. When the desired zones are chimed,
press [
ENTER].
12.15 KEYPAD MUTING*
Press and hold the [CLEAR] key for 3 seconds to enable or disable keypad muting. When muted, the keypad will only
beep when a key is pressed or when the keypad emits a Rejection or Confirmation Beep. All other beep functions
are disabled.
12.16 KEYPAD BACKLIGHT (1686H and 1686V Only)
The illumination level behind the keys can be modified to suit the user’s needs. There are four backlight levels. The
[
MEM] key is used to set the desired level. Each consecutive push of the [MEM] key will increase the backlight level
until the maximum level is reached. After reaching the maximum level, the backlight level will return to the lowest
level and the whole process is repeated. To change the backlight level:
* Not to be used with UL installations
How do I Modify The Backlight?
1) Press and hold the [MEM] key for 3 seconds
2) The [
MEM] key will illuminate
3) Press the [
MEM] key to set the desired backlight level
4) Press [
CLEAR] or [ENTER] to exit