Filter
Top Products
EDS-2 Settings 39
BANK F
Switches 1, 2, 3, 4, 5, 6: LQ Font Selection
Turn these switches on or off to form the pattern that identifies the font you want
to use for LQ printing.
Note:
Bank C Switches 1 and 2 must be in the correct position before this setting has
any effect.
EDS-2 Settings
The following details all of the settings you can make for EDS-2. For
communications protocol settings (Banks A and B), the matching settings you
have to make in your MS-DOS AUTOEXEC.BAT file or with the Ports option
of the Windows Control Panel are also provided.
BANK A
Switch 1: Data Length
Specifies the number of bits that the computer transmits as one byte. This setting
is normally 8.
Font SW1 SW2 SW3 SW4 SW5 SW6
Roman ON ON ON ON ON ON
Sanserif OFF ON ON ON ON ON
Courier ON OFF ON ON ON ON
Prestige OFF OFF ON ON ON ON
OCR B OFF ON OFF ON ON ON
Orator OFF OFF OFF ON ON ON
Data Length SW1 DOS/Windows Setting
8 bits ON 8
7 bits OFF 7