Filter
Top Products
– 22 –
ENGLISH
6-4. Adjustment Mode
There are the following four adjustment modes.
The device will enter the adjustment mode if your turn it on while pressing the
FEED switch.
The Self Printing Mode is entered by releasing the FEED switch after the buzzer
sounds once.
(Holding down for 2 more seconds)
Adjusting the Dot Alignment Mode is entered by releasing the FEED switch after
the buzzer sounds twice.
(Refer to Appendix G.)
(Holding down for 2 more seconds)
The Hexadecimal Dump Mode is entered by releasing the FEED switch after the
buzzer sounds three times.
(Holding down for 2 more seconds)
The Black Mark Sensor Alignment Mode is entered by releasing the FEED switch
after the buzzer sounds four times.
(Refer to Appendix H.)
If the buzzer sounds five times or more, immediately turn the power off as the
adjustment mode is cancelled.
▼
▼
▼
▼