Filter
Top Products
– 10 –
5.3 Setting the EEPROM
The following command from the host computer is used to make the EEPROM settings.
a) EEPROM settings command
<ESC> #N, n1 n2 n3 n4 <LF> <NUL>
N: Memory switch no.
n1 n2 n3 n4: Setting data
For more details, refer to “Programmer’s Manual”.
b) Memory switch 0
N = 0
n1: Always 0
n2: Always 0
n3: Always 0
n4: Mode select
c) Memory switch 1
N = 1
n1: Sensor select
n2: Start-position detect
n3: Zero style
n4: International character set
0 Page mode (Default)
1 Line mode
Parameter Setting 0 (Default) 1
n1 Sensor select Reflective sensor
(Black mark)
Transmissive sensor
n2 Start-position detect OFF ON
n3 Zero style Normal zero Slashed zero
n4 International character set See below
n4 Country n4 Country
0 USA 7 Spain #1
1 France 8 Japan
2 Germany 9 Norway
3 UK A Denmark #2
4 Denmark #1 B Spain #2
5 Sweden C Latin America
6 Italy