Filter
Top Products
– 15 –
2
Paper Jam, Case 2: Removing paper from near the cutter.
(Procedure)
1) When paper is jammed inside the cutter, if it cannot be
removed by the procedure in Case 1, take out the
screws on both sides of the presenter, as shown in the
figure.
2) Slide the presenter along the * part in the figure, sepa-
rating the presenter and the cutter, then remove the
jammed paper.
3) After removing the jammed paper, slide the presenter
back, following the procedure in 2) in reverse order,
then fasten it in its original position using the screws.
Note) When fitting the presenter with the cutter in 3)
above, be careful not to get the two wires shown in
the figure caught between the presenter and cutter.
c) Other errors
●
Data errors (<ESC> “PC” command: defines character and bar code data)
A data error will occur if an invalid character or bar code type is selected or if the print result
extends outside the print area. When a data error occurs, all commands become invalid (character
strings and bar codes are not printed). However, the printer will not go off line and the LEDs will
not light up.