Filter
Top Products
1 When Power is ON
SW Input Operation
SW1 Self-test Print
SW2 Hex Dump Mode
2 When in Sensor Adjustment Mode and Power is ON (Sensor Adjustment Mode is selected using by
setting the DIPSW1-4 on the main board to OFF.)
SW Input Operation
No SW Input Sensor Adjustment Mode for PE/Black Mark
3 When Online
SW Input Operation
SW1 Paper Feed (*1)
SW1 + SW2 (Hold for 2 sec.) Printer Software Reset
*1) Details for Paper Feed Specifications
Presenter Contact Status Black Mark Function Paper Feed Specifications
Non-contact Disabled Paper feed continues while SW1 is input
Enabled Performs TOF operation
Contact Disabled Paper Feed + Full Cut + Presenter Paper Discharge
Ignores SW input under the following conditions
• When LF motor is operation
• When paper is being supplied to the presenter
Enabled TOF + Full Cut + Presenter Paper Discharge
Ignores SW input under the following conditions
• When LF motor is operation
• When paper is being supplied to the presenter
4 When errors occur
SW Input Operation
SW1 Paper Discharge (*2)
Function executed only under the following conditions
• Cover is closed • No Paper
SW2 Error cancel operation (according to MSW1-E settings)
*2)Paper Discharge
This function cancels the paper wait state of the platen that exists when there is no paper detected
when printing by feeding paper. Paper can be easily removed without opening the cover, by using this
function. However, caution must be exercise in using this function when there is no paper being
waited for at the platen because over use can damage the print head.
Status
LED Specifications
Power LED Error LED
Normal State ON OFF
Auto-recovery Error Printing stops because of Blink 500msec OFF
detection of the high
temperature of the head
Recoverable Errors PE Error ON Blink 500msec
NE Error ON Blink 2000msec
Cover Open Error ON ON
Black Mark Error ON Blink 500msec
Non-recoverable Errors Auto-cutter Errors OFF Blink 125msec
Presenter Paper Jam Errors OFF Blink 250msec
FLASH Access Errors OFF Blink 500msec
EEPROM Access Errors OFF Blink 750msec
SRAM Access Errors OFF Blink 1000msec
Thermistor Errors OFF Blink 1500msec
Power Voltage Errors OFF Blink 2000msec
18