Filter
Top Products
MC
2
Power Systems User's Guide Chapter 7: Troubleshooting
1110227 Revision 2
November 2006 29
Chapter 7: Troubleshooting
The following table describes some of the most common troubleshooting options for the
MC
2
power systems:
Symptom Possible Cause Possible Solution
No output Re-settable fuse
See “
No Output Reset
Procedure
”
Power system not charged Charge Power System
Power system section not
connected
Connect both sections of
power system together (26
Amp-Hour unit only). See
“
Preparing for Operation.”
Power output disconnect
switch in OFF position
See “
Preparing for Operation”
in the MC
2
Power System
Series 35 Amp-Hour topic.
Reduced runtime Power system not charged Charge power system
Battery life exceeded
Contact Stinger Medical
C.A.R.E. department
Component not powering Component not plugged in Plug in to power system
No output from power system
See “
No Output Reset
Procedure
”
Dip switch incorrectly set
26 Amp-Hour units: see
“
User-selectable Switch
Settings
” OR 35 Amp-Hour
units: see “
User-selectable
Switch Settings
”
Power system not charged Charge power system
Overload
Contact Stinger Medical
C.A.R.E. department
Power system beeping Power system discharged Plug in to charge
Not charging Faulty wall outlet Plug into alternate wall outlet
Faulty cord set Replace cord set (per policy)
Charger timed out
See “
Charger Timed-out
Reset Procedure
”
Battery life exceeded
Contact Stinger Medical
C.A.R.E. department