Sun Microsystems 440 Server User Manual


 
14 Sun SNMP Management Agent Addendum for the Netra 440 Server April 2004
Fans and Fan Trays
The Netra 440 server fans in the fan trays are identified in the ENTITY-
MIB::entPhysicalTable by the entPhysicalDescr of Fan number, where number is a
number in the range from 0 to 3. The fans are represented in the following tables that
extend the entPhysicalTable:
SUN-PLATFORM-MIB::sunPlatEquipmentTable
SUN-PLATFORM-MIB::sunPlatFanTable
Note The fans in fan trays 0-2 have certain sensors that give status and failure
information, whereas the fan in fan tray 3 does not; therefore, the information in the
remainder of this section will apply only to the fans in fan trays 0-2, not the fan in
fan tray 3. Also, if the fan in fan tray 3 fails, the Netra 440 server automatically shuts
down and no SNMP traps are generated.
The fans in fan trays 0-2 contain a tachometer used to indicate the current speed of
the fan expressed in revolutions per minute (RPM). The tachometers are identified
by their entPhysicalDescr of Fan number Tachometer, where number is a number in
the range from 0 to 2 corresponding to the fan tray being monitored. The fan
tachometers are represented in the following tables that extend the entPhysicalTable:
SUN-PLATFORM-MIB::sunPlatEquipmentTable
SUN-PLATFORM-MIB::sunPlatSensorTable
SUN-PLATFORM-MIB::sunPlatNumericSensorTable
Fan Failures
If the speed of a fan falls below the threshold indicated by its tachometer's
sunPlatNumericSensorLowerThresholdNonCritical value, the fan is considered to
have failed and the following will occur:
The sunPlatEquipmentOperationalState value for the fan will change from
enabled(2) to disabled(1) and a sunPlatStateChange trap will be generated
with the form shown in
TABLE 2.
A sunPlatEnvironmentalAlarm trap with a sunPlatNotificationPerceivedSeverity
value of warning(5) will be generated for the fan with the form shown in
TABLE 3.
The sunPlatEquipmentAlarmStatus value for the fan will change from
cleared(7) to warning(5) and a sunPlatAttributeChangeInteger trap will be
generated with the form shown in
TABLE 4.