Filter
Top Products
5-4
S
UPERSERVER 6014L-T User's Manual
5. Once the processor is properly
seated in the socket, turn the lock
mechanism clockwise with the fl at-
head screw driver to lock it.
Repeat the above steps if you wish
to install a secind processor.
Heatsink mounting holes
Screw# 1
1. Do not apply any thermal grease to the
heatsink or the CPU die; the if the required
amount has already been applied
.
2. Locate the four heatsink mounting holes
on the serverboard.
3. Place the heatsink on top of the processor
and insert the heatsink's four pegs into the
heatsink mounting holes.
4. Using a Phillips screwdriver, screw in
two diagonal screws (i.e. the #1 and the #2
screws) until just snug (do not fully tighten
the screws, which may damage the proces-
sor.) Repeat the same step to install the
remaining two screws.
5. Repeat the steps above to install an-
other heatsink to the secind processor (if
installed).
Screw# 2
Installed processor
Installed heatsink
Installing the Heatsinks