Filter
Top Products
SBA-7142G-T4 Blade Module User’s Manual
1-2
1-3 Blade Module Features
Table 1-1 lists the main features of the SBA-7142G-T4 blade module. See the
proceeding section for components typically included in a blade system and other
optional components. Specific details on the SBA-7142G-T4 blade module is found in
Chapter 4: "Blade Module Features" on page 4-1.
Processors
The SBA-7142G-T4 blade module supports up to four 1944-pin G34 socket AMD
Opteron 6100 series processors.
Refer to the Supermicro web site for a complete listing of supported processors (http://
www.supermicro.com/products/superblade). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the SBA-7142G-T4 blade module are found
in Chapter 3: "Setup and Installation" on page 3-1.
Memory
The SBA-7142G-T4 blade module has sixteen 240-pin DIMM sockets that can support
up to 64 GB of ECC Unbuffered DDR3-1600/1333/1066 SDRAM or 256 GB of ECC
Registered DDR3-1600/1333/1066 SDRAM DIMMs. Both interleaved and
non-interleaved memory are supported, so you may populate any number of DIMM
slots.
Please refer to the Supermicro web site for a list of supported memory
(www.supermicro.com/products/superblade). The detailed specifications for a blade
module will contain a link to a list of recommended memory sizes and manufacturers.
Table 1-1. SBA-7142G-T4 Blade Specification Features
Mainboard
BHQGE (proprietary form factor)
Blade Module Chassis Dimensions (HxWxD): 11.32” x 1.67” x 20.5”
Processors
Supports four 1944-pin G34 socket AMD Opteron 6100 series processors
per blade module. Please refer to our web site for a complete listing of
supported processors.
FSB Speed HyperTranport HT 3.0
Chipset AMD SR5650 & SP5100 chipset
Graphics Controller One embedded Matrox G200eW Graphics chip with 16MB of SDRAM
BIOS 16 Mb AMI
®
SPI Flash EPROM BIOS
Memory Capacity
Sixteen 240-pin DIMM sockets per node supporting up to 256 GB of ECC
Registered DDR3-1600/1333/1066 SDRAM DIMMs or 64 GB of ECC
Unbuffered DDR3-1600/1333/1066 SDRAM DIMMs.
SATA Controller SATA Controller SP5100 on-chip controller for four Serial ATA drives total.
Hard Drive Bays Four (4) hot-swap drive bays for 2.5" SATA disk drives or SSD drives.