Symbol Technologies LS 3603 Scanner User Manual


 
1-10
LS 3603 Product Reference Guide
Battery Box Operation
When using the LS 3603 with a battery box, you can use either an alkaline
battery (recommended), or a nickel-cadmium rechargeable battery. Low
battery power is signaled by four short, high tone beeps, coupled with
scanning interruptions. If this occurs, change or recharge the battery as soon as
possible.
Changing the Battery
To open the battery box, push up on the flanges at one end of the pack.
Remove the old battery.
Insert the new or recharged 9-volt battery into the battery box. Match the
positive (+) and negative (-) terminals on the battery with the
corresponding terminals in the battery box.
Recharging a Nickel-Cadmium Battery
Remove the battery from the battery box and place it in the recharging
unit (not supplied by Symbol).
To recharge the battery, follow the instructions supplied with the
recharging unit.