Filter
Top Products
9-2
LS 9208 Product Reference Guide
Connecting Using Wand Emulation
To perform Wand Emulation, connect the scanner to a portable data terminal, or a controller
which collects the wand data and interprets it for the host.
Figure 9-1. Wand Emulation Connection
1. Connect the Wand Emulation interface cable to the rear of the scanner, as
described in Installing the Interface Cable on page 1-3.
2. Connect the other end of the interface cable to the Wand port on the portable data
terminal or controller.
3. Scan the appropriate bar codes in this chapter to configure the scanner.
Interface cable
Wand port
Portable data
Terminal