Filter
Top Products
TANDBERG 6000 MXP
18
Leave these settings unchanged if no special needs are required. See chapter
General Settings
for more information.
5. Screen Settings
When using wide screen (16:9) monitors, set VGA Monitor Format to Wide (16:9).
TANDBERG also recommends the following settings:
Picture Layout to Picture outside Picture as this mode provides a display
layout optimized for wide screen monitors.
Auto Layout to "On". The display layout may be changed at any time using
the layout button on the remote control.
Use screen as local PC monitor to "On".
PC Picture Format to "Wide" (depends on your PC's VGA output).
6. Software Options
This menu item will display the currently installed options (such as MultiSite,
Presenter and high bandwidth options). To activate any purchased software option
for the system, an option key must be obtained and then entered into the Software
Options menu (see paperwork accompanying the system for option keys). The
MultiSite and Presenter option keys should be entered under “New Option Key”. Any
bandwidth option keys should be entered under “New Bandwidth Key”. You may
need to restart the system for options to take effect. For more information on these
options, please contact your TANDBERG representative.
7. Date and Time Settings
Select your preferred Date and Time Settings.
8. Save changes
Remember to select the on-screen Save icon on the bottom of each menu (highlight
using arrows and use the OK button to select) to save the changes you may have
made.
Network configuration:
1. Open the Network menu
Press OK/Menu to open the Menu, if not already displayed. Select Control Panel -
Network to open the Network menu.
2. ISDN configuration
Set the Network type to the desired network. Specify the settings for the selected
network in the relevant menu. Enabled but unused ISDN lines (i.e. lines not active)
should be disabled. For details, follow the instructions in ISDN /External/Leased
E1/T1. See also the examples in Appendix 9: Connecting the system to the Switched